- 15mm Clear Toughened & Heat Soaked
- Sizes up to 750mmW have 4 bottom drill holes
- Sizes from 800mmW have 6 bottom drill holes
- Perfect for use with Standoffs and Nano deluxe handrail for 15mm glass.
Heat Soaking is an extra processing step that takes place after the glass is toughened. Glass is put in special racks and placed in a heat soak oven which heats up the panels to a certain temperature, holding this temperature for some hours, and cooling again to room temperature. This test seeks to induce breakage in the oven of any panel with NiS inclusion and hence reduce the chance of on-site breakages. Glass House utilizes a heat soak oven meeting the requirements of BS EN 14179-1:2005. Please check with relevant Building Code of Australia regulations and/or Australian Standards regarding specific requirements for heat-soaked tempered glass. Please also check with your certifier that this product satisfies the local code with regard to glass balustrades.
An engineering certificate can be provided.
An engineered balustrade design is available for the Standoff Point Fixed Balustrade.
Depending on certification requirements of the installation location, a standard balustrade design document may be sufficient OR site specific certification may be required (eg Form 15 for QLD, Reg 126 for VIC etc).
It is the responsibility of the purchaser of balustrade barrier products from Glass House AU to select products that are appropriate for the installation location/situation and that it is installed as required by regulation. Do not install balustrade barrier products until certification requirements are finalised.
Available for local delivery only or collection
Free collection from Gold Coast, Brisbane, Adelaide, Melbourne or Cardiff
Delivery is to the below areas only, See delivery and collection maps
Sunshine Coast, (as far north as Noosa)
Brisbane metro
Gold Coast
Northern Rivers, (north of Ballina)
Tweed
Melbourne metro
Adelaide metro
Cardiff metro,
Not available in Perth
If outside of these areas please ask.
